The atomizer itself consists of the following parts :
cone/cap with connection for standard 510 type tips
base – with positive and negative poles integrated and standard 510 connection type
With an attractive design, made with high quality materials and processed with cutting edge technology, BF by aero is an advanced rebuildable bottom feeding atomizer.
- Two air intake holes are placed on opposite sides of the 510 connector, directing the air through the central channel (used also for feeding the juice).
- The lid is screwed on – so it can be sealed against e-liquid leakage and for added safety against accidental detaching.
- The resistance is attached using stainless steel screws.
- The sealing material of the positive pin is made from a high temperature resistant material, certified for use in the food industry.
The electrical connections between the battery and the atomizer, including routing inside the atomizer, are completely mechanical, there are no wires, no soldering points, no lead solder, no possibility to break in time.
Electrical losses are practically non existant and there is no risk of failure in time or short-circuit from wear and tear.
Approximate Dimensions:
Length: 30mm (without drip tip and 510 connector)
Diameter: 13mm (at widest point)
There are different finishes and colors available, depending on the base material of the atomizer.
Pure and satin finishes both use a special treatment that hardens the surface and protects from scratches.
Directions :
place the BF by aero on your bottom feeding PV
unscrew the cone from the base
make a coil according to your preferred method
open the two screws on the BF by aero
place the wick and coil assembly between the two posts and place the resistance wire ends in the designated holes in the posts
tighten back the two screws – do not use excessive force, the screws will insure a good electrical contact immediately
after the set up is ready and tested: the wick/mesh and coil lights up completely and equally on all coils, wet the wick/mesh with 2-3 drops of liquid
burn the wick/mesh a few times (2-3 seconds per activation) in order to allow the liquid to penetrate easier into your mesh/wick
tighten the cone back on the base and vape
Please note:
There is no drip tip included!